EHWIC-ESG-P on 2911 and 1921

Question:

 Ok, WS-C3750V2-48PS-S I recently recieved the EHWIC so I can eliminate a cheap switch at our remote sites, and have POE as well so I can power the IP phone and camera.  I have installed the card into the router and it has no problems recognizing the card, ports gig 0/0/0 - 0/0/3.  I upgraded to Version 15.2(3)T2 on the router, but still having a couple problems.

1.  I do not have any POE commands
2.  For some reason I cannot get it configured properly

     All I want to do is use it as a switch for the local lan, which is literally a computer, printer, ip phone and camera.  The router has a T1 serial card for access to the network.  No problems with the current config, gig 0/0 lan and serial 0/0/0 is the T1.  How do I go about making all the ports on the EHWIC part of the LAN?

Answer:

It is an expected behavior that when there are no devices plugged into any switch ports that the switch ports will be down and that the Vlan will be down. So if you would be willing to do it, please plug your laptop back in and try the show ip interface brief and show arp again.

Also I wonder if you would check on and report some things to establish what is working and what is not working.
With the laptop connected to a switch port, and from the command line of the router:
- can you ping the laptop?
- can you ping the router gateway at 10.0.0.1?
- can you ping something in the network beyond 10.0.0.1?
then from the laptop:
- can you ping the router Vlan interface at 10.0.200.1?
- can you ping the router interface at 10.0.0.11?
- can you ping the router gateway at 10.0.0.1?
- can you ping anything in the network beyond 10.0.0.1?

And it occurs to me WS-C3750X-12S-S Price to ask whether the device at 10.0.0.1 has a route to 10.0.200.0?. For more info, please refer to http://www.pereza.info/es/blog/static-pat-ms-exchange-router